3D printed ITX Case

Reading time ~1 minute

Why buy a case when you can print one?


  • Prints without any support
  • Fits one HDD and one SSD
  • Build for an ITX motherboard and low profile CPU Fan

The whole case, which consists off of three parts, weighs a little bit over 600g. I printed it on my Prusa i3 MK3s with 0,3mm layer height and it took ~11 hours total. For the mesh I used a little trick and just used infill in the slicer. So no top or bottom layers and just 3 layers high in total.

3DCase_1 3DCase_2 3DCase_3 3DCase_4 3DCase_5